ADLINK Technology cPCI-6860A Series User Manual download pdf (Page 21)

Getting Started 13

Figure 2-4: Unlatching and removing a cPCI PSU.

2. Pull outwards to remove the PSU.

3. Insert the new PSU module, push on the handle until it

latches into position, and replace the retaining screws.

2.3 Rear Transition Module Installation/Removal

The installation and removal procedures for a Rear Transition

Module (RTM) are the same as those for CompactPCI boards.

Because they are shorter than front boards, pay careful attention

when inserting or removing RTMs. Only models with an “R” at the

end of the model number support RTMs.

Note: We strongly recommended the use of RTMs with AB type

connectors to prevent the damage to the backplane during

RTM installation.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 75 76

9U Dual-System 1
CompactPCI Platform 1
User’s Manual 1
Getting Service from ADLINK 3
Table of Contents 5
List of Figures 7
1 Introduction 9
1.2 Specifications 10
1.3 Mechanical Layout 11
4Introduction 12
1.4 cPCIS-3320 Configurations 13
1.5 System Architecture 13
6Introduction 14
Introduction 7 15
1.6 Power Distribution 16
2 Getting Started 17
10 Getting Started 18
Getting Started 11 19
12 Getting Started 20
Getting Started 13 21
2.4 Drive Bay Access 22
2.5 Powering Up the System 23
2.6 System Alarm Board 24
3 Backplane 25
3.2 Mechanical Drawing 26
Backplane 19 27
3.3 Connector Pin Assignments 28
System Slots [8-P2], [14-P2] 29
System Slots [8-P3], [14-P3] 30
System Slots [8-P4], [14-P4] 31
System Slots [8-P5], [14-P5] 32
Peripheral Slots 33
26 Backplane 34
Pin Z A B C D E F 34
Backplane 27 35
28 Backplane 36
Pin Z A B C D E F 36
Backplane 29 37
CMM Slots 38
CMM Slots [S55] 39
Other Connectors 40
AC-Inlet Connector [CN8] 41
Power LED Connector [J5] 42
DEG# Connector [J8] 42
INH# Connector [J9] 43
FAL# Connector [J10] 43
3.4 Jumper Settings 44
4 Cooling System 47
Intake Fans 48
Exhaust Fan 49
42 Cooling System 50
Cooling System 43 51
5 Power Supply Unit 53
5.3 Input Characteristics 54
5.4 Output Characteristics 55
5.5 Pin Assignments 56
6 Chassis Management Module 57
CMM Mechanical Diagrams 58
Chassis Management Module 51 59
Features 60
Specifications 61
6.2 CMM Setup 62
Chassis Management Module 55 63
56 Chassis Management Module 64
Chassis Management Module 57 65
58 Chassis Management Module 66
6.3 CMM Firmware Update 68
Chassis Management Module 61 69
62 Chassis Management Module 70
Chassis Management Module 63 71
Important Safety Instructions 73
Warranty Policy 75
68 Warranty Policy 76

Comments to this Manuals

No comments

ADLINK Technology cPCI-6860A Series User Manual Page 21

Comments to this Manuals

Related products and manuals for Chassis components ADLINK Technology cPCI-6860A Series